RP-200 + conveyor belt 3m
Specification:
reinforced welded construction (fully disassemblable)
additional rear shaft for flywheel/belt
adjustable clearance between knives
induction hardened gears
reinforced frame made of metal profiles
extended reinforced profile foldable inlet funnel with safety switch
pin-ball hitch for trailer
three-point tractor attachment system
Minimum/recommended power 90/150 HP
Internal width of mechanism 300 mm
Max. cutting diameter of branches (fresh soft wood) 160 mm
Max. cutting diameter of branches (fresh hard wood) 150 mm
Max. cutting diameter of branches (dry hardwood) 140 mm
Spacing between shafts 200 mm
Knife thickness 15 mm
Gear diameter 300 mm
Cutting mechanism housing thickness 20 mm
Recommended PTO shaft speed 440-540 rpm
Recommended overload clutch 2500-3500 Nm
Cutting knife construction Wear-resistant steel with increased hardness
Feed hopper 62/38 cm
Chipper mounting system Three-point suspension system
Trailer hitch with pulling capacity 1000 kg
Belt length / width 300/30 cm
Conveyor belt drive Hydraulic motor
Conveyor belt turning angle 90˚
Length of cut branches (6 knives) 18-30 cm
Length of cut branches (8 knives) 15-25 cm
Chipper weight with conveyor belt 600 kg
